Briteq BT-2505 Mode D'emploi page 7

ENGLISH
Focus Adjust
 Press the MENU button for at least 5 seconds to activate offset mode
 Use DOWN and UP button until
is shown on the display.
 Press the ENTER button and the unit will focus on "tilt 135°" position
 Press the ENTER button and the unit will focus on "tilt 45°" position
 Press the ENTER button and the unit will focus on "pan 0°" position
 Press the ENTER button and the unit will focus on "pan 90°" position
 Press the ENTER button and the unit will focus on "pan 180°" position
 Press the ENTER button and the unit will focus on "pan 270°" position
 In the Previous 6 steps you are able to adjust the focus with the UP/DOWN buttons on the unit
To go back to the main functions without any change wait 8 seconds.
Pan offset
 Press the MENU button for at least 5 seconds to activate offset mode
 Use DOWN and UP button until
is shown on the display.
 Press the ENTER button so the display starts blinking.
 Use DOWN and UP button to adjust the pan home position.
 Once the position is selected, press the ENTER button to setup OR automatically return to the offset
functions without any changes by pressing the MENU button
 To go back to the main functions without any change wait 8 seconds.
Tilt offset
 Press the MENU button for at least 5 seconds to activate offset mode
 Use DOWN and UP button until
is shown on the display.
 Press the ENTER button so the display starts blinking.
 Use DOWN and UP button to adjust the tilt home position.
 Once the position is selected, press the ENTER button to setup OR automatically return to the offset
functions without any changes by pressing the MENU button
 To go back to the main functions without any change wait 8 seconds.
Briteq
®
OPERATION MANUAL
9/69
ENGLISH
HOW TO CONNECT THE UNIT BY DMX
The DMX-protocol is a widely used high speed signal to control intelligent light equipment.
You need to "daisy chain" your DMX controller and all the connected light effects with a
good quality XLR M/F balanced cable. To prevent strange behavior of the light effects, due
to interferences, you must use a 90Ω to 120Ω terminator at the end of the chain. Never
use Y-splitter cables, this simply won't work!
Each light effect in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode.
 HOW TO SET THE THE RIGHT STARTING ADDRESS:
Refer to the previous chapter (DMX-512 address setting) to learn how to set the starting address on this unit.
The starting address of each unit is very important. Unfortunately it is impossible to tell you in this user
manual which starting addresses you have to set because this completely depends on the controller you will
use... So please refer to the user manual of your DMX-controller to find out which starting addresses you
must set.
BT250S Briteq
®
OPERATION MANUAL
10/69 BT250S