Trek RIDE+ Pro Manuel Du Propriétaire page 30

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The battery-pack can both be charged in the bike or it can be removed from the bike for charging.
Li-Ion batteries such as are used in the electric bicycle, have no 'memory-effect'. This means that
the battery capacity is not influenced if the battery is recharged before it is completely empty. You
can recharge after every ride. However, you will get the most from your battery pack if, for the first
three charges, you use it until only one unit is showing in the 'fuel gauge' on your display. When it
is necessary to re-charge, the battery-pack will emit a 'beep'.
Batteries are best charged at temperatures around 20˚C, so avoid warm locations. When coming in
out of the cold, allow the battery-pack to get up to room temperature (about 20˚C) before charging.
• Power supply 100-240V
The power supply will adjust automatically to the local voltage.
• Charging
Connect the connector of the power supply to the battery-pack.
Connect the power supply to an appropriate power source.
Warning: Replace a damaged power cable immediately to prevent an electric shock.
The light at the charging port of the battery will turn red. It will turn yellow as soon as charging starts.
As soon as the yellow light on the battery charging port turns green, the battery-pack is fully
charged. Disconnect both the connector from the battery-pack and the power source.
Charging a fully discharged battery-pack usually takes about three to four hours. After one
hour of charging, the battery will already be charged up to 80% of its capacity.
The batteries with the round charging connector can be left connected to the power indefinitely.
The power supply electronics will take care of the correct charging procedure. However, you will save
energy
by disconnecting the power supply when the light in the charging port has turned green.
NOTE: Since the computer inside the battery saves the system mileage and settings,
we discourage the use of a second battery. A second power supply would be a better solution.
The battery is very durable. The capacity is guaranteed for 600 charge cycles or 2 years (whichever
situation comes first).
Instructions for Use
31

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ride+ easyRide+ easy ii

Table des Matières