Installation Information - Alecto SA-300 Mode D'emploi

INSTALLATION INFORMATION:

Attach the ceiling plate using the included plugs and screws to the ceiling on a location
of choice. Wall mounting is not recommended for smoke detection. Then put the de-
tector to the ceiling plate and, twist clockwise to lock it in place. It will emit a beep and
be ready for use. Perform a first test by holding the key for three seconds. Also see the
paragraph: "Testing".
Ceiling
USING, TESTING AND MAINTENANCE:
Using:
The smoke detector works if the smoke detector has been mounted to the ceiling.
A red LED will light up and the smoke detector will beep briefly to let you know that it
has been activated, because the ceiling plate has switched a lever on the inside.
The red LED will now flash every 40 seconds. Once smoke is detected, the alarm will
sound. Once the smoke disappears, the smoke alarm will stop automatically.
Test:
Hold the button for at least 3 seconds. The operation is still correct if you hear 2 or
three signal tones. Check the smoke detectors weekly. In alarm status the smoke de-
tector will generate about 85dB(A). Do not use candles, open fire or cigarettes to test
the smoke detector.
Time-out function:
This function will deactivate the alarm for about 5 minutes. This function can be
enabled by pushing the HUSH/TEST button very shortly. The LED will now blink once
every 8 seconds to indicate the deactivated smoke alarm.
After 5 minutes, the alarm will be fully active once again. If there is (still) any smoke in
the environment, the alarm will go off again.
This function can be used repeatedly.