Memory - Medisana MTP Pro Mode D'emploi

5 Memory

5.1
Recording
the results
5.2
Displaying
stored results
4 Operating / 5 Memory
7. Instead of "2", the display now shows "3" for the third measurement.
The third measurement proceeds in the same way as the first (see
points 2 - 4).
8. Once the 3/MAM measurement has been taken, the cuff suddenly
deflates and a longer beep sounds.
9. The measured values SYS, DIA and PUL are shown on the display,
together with the WHO blood pressure bar
time, a longer beep sounds.
10. If the unit detects an arrhythmia during the measuring process, the
arrhythmia symbol
displayed. You may also hear 8 short beeps; these warn the user of an
irregular heartbeat.
11. If you do not press any buttons for approx. 1 minute, the device
automatically switches to standby mode.
NOTE
When the device is used, the errors Err 1, 2, 3, 5, 6 can occur in
the integrated circuit. Err 6 can only occur in 3MAM mode.
In 3MAM mode, errors Err 1, 2, 3, 5 do not cause the
measurement to be cancelled, unless they occur twice in
succession. The error display is always accompanied by 3 short
beeps.
This unit features 2 separate memories, each with a capacity of 99
memory slots. Results are automatically stored in the memory selected
by the user. When the memory is full, the oldest reading is always the first
to be deleted.
Press the MEMORY button
average value of all the measurements in the selected memory is
displayed. This average is indicated by "
When the MEMORY button
(switching between systolic, diastolic, pulse and date/time) of the last
measurement stored are displayed. If this measurement was taken in the
3/MAM procedure,
during the measuring process, the arrhythmia symbol
displayed, but not flashing. Press the MEMORY button
backwards through the stored readings.
If you do not press any buttons for approx. 1 minute, the device
automatically switches back to standby mode.
z
will flash eight times while the reading is
6
to display the stored readings. First, an
".
6
is pressed again, the individual readings
is displayed. If an arrhythmia was detected
o
display. At the same
z
will be
6
again to move
GB
23