Taking Blood Pressure Readings; Memory; Displaying Stored Results - Medisana MTP Mode D'emploi

51047_MTP_MiniFormat_neu.qxd:OA-Blutdruckmessgerät
GB 4 Operation / 5 Memory

4.3 Taking blood pressure readings

a. Press the START button
• All the display
• The cuff
• Pressing the START button
The unit switches off and the cuff deflates.
b. The measuring process begins automatically when inflation is complete by
releasing the pressure built up in the cuff. The display shows the current
pressure in the cuff.
Initially, deflation occurs at a constant speed. As soon as the pulse can be deter-
mined, deflation is synchronised with the beating of the heart until the measure-
ment ends. This procedure is accompanied by a beep and the heart symbol
flashes at the same time. The measurement is complete when the cuff suddenly
deflates and readings are displayed next to SYS, DIA and PUL.

5 Memory

5.1 Recording the results
This unit features 2 separate memories, each with a capacity of 99 memory slots.
Results are automatically stored in the memory selected by the user. When the
memory is full, the oldest reading is always the first to be deleted.

5.2 Displaying stored results

Press the MEMORY button
marked "A", of all readings in the memory selected is displayed.
When the MEMORY button
between systolic, diastolic, pulse and date/time) of the last measurement stored
are displayed.
Press the MEMORY button
dings. At the bottom left of the display, above the symbol MR (MEMORY RECALL),
the memory number for the reading is displayed. The readings are displayed in
reverse order. If, for example, seven readings are stored in total, reading No. 7 (the
last, most current measurement) will be displayed first, then reading No. 6 (the
second last measurement) etc.
5.3 Deleting memory
The data can be deleted from the memory selected by pressing and holding the
MEMORY button
"CL" ( CLEAR ) which indicates that all data have been deleted.
5.4 Switching off the uni
The unit switches off automatically after about 3 minutes, if no button is pressed
during this period. It can also be switched off by pressing the START button
The time and the personal memory selected are constantly shown in the display.
20
.
symbols will appear for approx. two seconds.
will then inflate. The increasing pressure is displayed numerically.
during inflation will stop the inflation process.
to display the stored readings. Initially, the average,
is pressed again, the individual readings (switching
again to move backwards through the stored rea-
for about 7 seconds. After 7 seconds, the display
t
31.08.2010 10:
shows
.