Memory - Medisana HGV Mode D'emploi

51222_HGV_Serbien_5spr.qxd:Blutdruckmessgerät
GB
4 Operation / 5 Memory
4.4
Switching off
the unit

5 Memory

5.1
Displaying
stored results
20
6. When the measurement is finished, the cuff is deflated completely. The
systolic and diastolic blood pressure and the pulse value with the pulse
symbol appear on the display
flashes next to the relevant coloured bar depending on the WHO blood
pressure classification (see page 16). The measured results will be announ-
ced in the language set if the language function is switched on. If the
unit has detected an irregular heartbeat, the arrhythmia display
flashes.
7. The measured values are stored automatically. A total of up to 120
measured values with time and date can be stored in two memories (U1
and U2).
The unit has an automatic switch-off function. The unit switches off automati-
cally after a minute if no buttons are pressed.
The unit may also be switched off using the START button
The time and the date are constantly shown in the display.
Up to 60 measurements (blood pressure and pulse with time and date) may be
stored in each of the blood pressure monitor's two memories. The measured
values are stored automatically. Press the MEM button
measured values stored. The unit displays the memory set (U1 or U2). Pressing
the START button switches to the other memory. The average measured
values of the last three measurements saved appear on the display if no button
is pressed for a duration of 5 seconds. An "A" (Average) appears instead of the
memory location number
the language function is switched on.
The values of the most recently saved measurement (memory location
number e.g. "01") including the flashing blood pressure indicator
displayed after pressing the MEM button
during the measuring process, the arrhythmia symbol
voice function has been activated, the device speaks the memory location
number, together with the saved blood pressure and pulse values and the
blood pressure assessment as per the scale in the World Health Organisation
guidelines (see pg. 16).
Repeatedly pressing the MEM button
measured previously. In memory recall mode the unit switches off auto-
matically after approx. 120 seconds if the last entry has been reached and the
MEM button has been pressed once more. Memory recall mode can be
exited at any time by pressing the START button
unit off. If all 60 memory locations in a memory are occupied, a new measured
value is saved whilst the oldest value is deleted.
09.12.2010 7:59 Uhr
. The blood pressure indicator
. The data is announced in the language set if
. If an arrhythmia was detected
displays the respective values
, which will also switch the
Seite 20
also
.
to call up the
are
also flashes. If the