Getting Started - Medisana MTP Pro Mode D'emploi

3 Getting started

GB
3.2
Using a Mains
Adaptor
3.3
Setting time
and date
3.4
Setting up the
user memory
20
WARNING
BATTERY SAFETY INFORMATION
Only replace with batteries of the same type, never use
Ÿ
different types of batteries together or used batteries with
new ones!
Insert the batteries correctly, observing the polarity!
Ÿ
Remove the batteries from the device if it is not going to be
Ÿ
used for an extended period!
Keep batteries out of children's reach!
Ÿ
Do not attempt to recharge these batteries! There is a danger
Ÿ
of explosion!
Do not short circuit! There is a danger of explosion!
Ÿ
Do not throw into a fire! There is a danger of explosion!
Ÿ
Keep unused batteries in their packaging away from metal
Ÿ
objects in order to prevent short circuiting!
Do not throw used batteries into the household refuse; put
Ÿ
them in a hazardous waste container or take them to a
battery collection point, at the shop where they were
purchased!
Alternatively, you can use the unit with a special mains adaptor
(MEDISANA Art.–No. 51036) This connects to the socket
the back of the unit. In this case the batteries remain in the unit.
Inserting the connector into the back of the blood pressure monitor
switches the batteries off mechanically. It is necessary, therefore, to plug
the mains adaptor into the mains socket first of all and then to connect it to
the blood pressure monitor. If the blood pressure monitor is no longer
being used, first remove the connector from the blood pressure monitor
and then pull the mains adaptor out of the mains socket. Doing this means
that the date and time will not have to be reset each time.
To set date and time press and hold the TIMER button
seconds. The symbol for the memory selected starts flashing. Now press
7
the TIMER button
and starts flashing. Press the MEMORY button
Press the TIMER button
6
MEMORY button to change the values.
The MTP Pro gives you the opportunity to assign readings to one of two
user memories, each of which provides 99 memory slots.
Press and hold the TIMER button
memory (USER) 1
1
between USER 1
1
6
.
again briefly. The year is now shown in the display
7
to go to month, day and time. Press the
7
for several seconds. The symbol for
5
in the display
and USER 2 by pressing the MEMORY button
2
2
provided at
7
for several
6
to change the year.
starts flashing. You can switch
5