Oceanic OCEACLIM120SR Guide D'utilisation page 61

Problems
The appliance
works but does not
cool the
temperature down.
The appliance
works but does not
cool the
temperature down.
No hot air in
heating mode.
Water leaks while
the appliance is
being moved.
Possible causes
- Verify if the set
temperature is higher than
the room temperature.
- Verify if a window or a
door is closed.
- Verify if any heater or
lamp is producing heat.
- Verify if the air filter is
dirty.
- Verify if the set
temperature is higher than
the room temperature.
- Verify if a door or a window
is opened.
- Verify if
producing appliance is in
use (a heater or lamp for
example).
- Verify if the air filter is
dirty.
- Verify if the air outlet is
blocked by any bulky
object.
- Verify if the set
temperature is lower than
the room temperature.
- Defrosting or cold-air
protection is activated.
- Water tank is full.
- The device is laid down or
the ground is not flat.
60
- Lower the set
temperature. (Please
refer to IV. Use.)
- Close the window or
door to stop hot air
from entering.
- Switch the(se)
appliance(s) off.
- Clean the filter.
(Please refer to V.
Maintenance and
cleaning.)
- Lower the set
temperature
- Stop hot air from
entering.
any heat-
- Turn off these
appliances.
- Clean the filter.
- Remove the
obstacles.
- Lower the set
temperature. (Please
refer to IV. Use).
- It is normal. The
appliance turns off
automatically at the
end of defrosting or
cold air protection.
- Drain water.
- Always position the
appliance up-right.
Solutions