Memory Card; Touch Panel Setup - ViewSonic ViewPad 10pi Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 73

Memory Card

SD memory card provides additional data storage space.
To install SD/SDHC card
1. Open card door.
2. Insert SD/SDHC card following the indicative mark.
3. Close the card door.
To remove the SD/SDHC card
1. For safe removal, go to Windows task bar and right mouse click on icon. Select
eject SD card option.
2. After Windows prompts, "The device is now safe to remove" open the card cover.
3. Push to eject the SD card from the slot.
NOTE!
Do not remove the memory card while it's being accessed. Sudden removal of the memory
card may cause data loss or unpredictable system behavior.

Touch Panel Setup

The touch panel of this device has been factory calibrated. In most cases,
recalibration is not necessary. However, due to the nature of capacitive touch panel,
change of geographical location may require recalibration for the new environment
conditions.
If touch panel is experiencing improper behavior, please perform touch panel
calibration procedure as below.
1. Tap on
(ILITEK) icon to open touch panel calibration menu.
2. Place the device on a flat table top. Avoid any touch contact to the touch panel
while performing the calibration.
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Vs14406

Table des Matières