Peg-Perego Viaggio 0+1 Convertible Notice D'emploi page 22

models, which did not have the homologation label.
IMPORTANT
• "Viaggio 0+1 Convertible" must be rear-facing
when used as a Group 0+ car seat and must be
forward-facing if used as a Group 1 car seat.
• Do not install "Viaggio 0+1 Convertible" in seats
that are not in the direction of travel or are
transversal with respect to the direction of travel.
• If used as a Group 0+ car seat on the front seat, the
front airbag must be deactivated.
• If the child seat is installed on the front seat in
Group 1 configuration, it is advisable to place it as
far as possible from the dashboard.
• This item has a progressive serial number.
• If you experience problems during the installation
of Viaggio 0+1 Convertible, lift or remove the
headrest.
WARNING
• Carefully read the instructions before use and keep
them in a safe place for future reference. Failure
to thoroughly follow the instructions for the
installation of the car seat could expose your child
to serious hazards.
• Viaggio 0+1 Convertible must be assembled and
installed by adults.
• The car seat must be assembled and installed when the
child is not seated in it.
• When travelling, never hold your child in your arms or
allow him to sit on the car seats. If you have to brake
suddenly, even at low speed, the child could easily be
thrown forwards.
• Do not insert fingers into the mechanisms.
• Pay particular attention to luggage or other objects
that could injure the child sitting in the car seat during
an accident.
• Do not use installation methods other than those listed
here because they could cause the detachment of the
car seat during an accident.
• Make sure that the three-point seatbelt used to fix the
car seat is taut and not twisted. If the belt has been
stretched in an accident it should be replaced.
• Do not leave the your child unattended in the seat in
the car: watch your child even when he is asleep.
• Never remove the child from the seat when the car is
moving.
• Check that the child car seat is not blocked by a
moving part of the seat or a door.
• Adjust the height and tension of the belts, checking
that they are as tight as possible without causing
discomfort to the child. Check that the safety belt is not
twisted and the child cannot unfasten it.
• This car seat is designed only for short naps.
• Do not leave the car seat in the car if exposed to direct
sunlight, because some parts could overheat and cause
injuries to the delicate skin of your child. Check the seat
is not too hot before seating your child.
• Do not use the child car seat without the lining. This
lining cannot be replaced by other lining unless it
has been specifically approved by the manufacturer
because it is an integral part of the seat and is essential
for safety purposes.
• If in doubt, contact the manufacturer or retailer of this
child car seat.
• Do not remove the adhesive and sewn labels. The
removal of these labels could result in the product not
complying with the law.
• Do not use the child car seat if it is broken, if parts are
missing, if it is second-hand or if it has been subjected
to heavy impacts as a result of accidents, because it
may be structurally damaged and be a hazard.
• Do not alter the product.
• Contact the post-sales service for repairs, the
replacement of components and information on the
product. Go to the last page of this manual for further
information.
• The car seat must always be fixed in the car, even
when there is no child sitting in it. If you have to brake
22