Using The Pendulum Action Switch; Dust Removal; Dust Collection; The Parallel Stop - Batavia Maxx Série Mode D'emploi

English
Do not set the mitre angle during
use.
• Slacken the Allen screws (III) using the
Allen key (II).
• Tilt the saw shoe (I) to the required
position.
• Tighten the Allen screws (III) using the
Allen key (II).
13. Using the pendulum action
switch
The pendulum action switch is used to set
the way in which the teeth of the saw blade
grip the material. The pendulum action
switch can be set to 4 positions.
Do not set the pendulum position during
use.
Turn the pendulum action switch (9) to
required position according to the material
to be worked. Refer to the table below to
select the required position.
Material
Wood . . . . . . . . . . 1 — 3
Plastics . . . . . . . . . . . 1
Aluminium . . . . . . . . 0 — 1
Steel . . . . . . . . . . . . 0
Ceramics . . . . . . . . . . 0
Rubber . . . . . . . . . . . 0
8
7062849-Jig_Saw_800W-Ma-1803-09.indb 8
Pendulum position

14. Dust removal

The saw is equipped with a changeover
switch for dust removal (7).
Set the switch to II to open the dust
14.1
outlet. The dust is thus blown away,
which improves the visibility of the cut-
ting line.
Set the switch to I to close the outlet.
14.2
When connecting a vacuum cleaner
(see next chapter), set the switch to the
I position.

15. Dust collection

This jig saw is a powerful tool that can pro-
duce a lot of sawdust. By connecting the jig
saw to a vacuum cleaner, a clean dust-free
operation is possible.
Do not use dust extraction when cutting
metal.
Dust extraction is not possible for mitre
cuts.
Slide the dust nozzle (6) all the way into
15.1
the opening until the snap-in nose visi-
bly and audibly locks into place.
Connect the dust nozzle (6) with a vac-
15.2
uum cleaner or dust extractor.
When sawing wood, it is best to use an
additional dust protection mask since
wood dust is a health hazard.

16. The parallel stop

To cut parallel to a wood edge, you can use
the enclosed parallel stop (15).
In order to fix the parallel stop (15),
16.1
loosen the fastening screws (11)
slightly. Using the centimetre scale on
the parallel stop (15), you can adjust the
distance between the stop bar and the
saw blade.
22-03-18 11:07