Accessories - Hendi PROFI LINE 410 Mode D'emploi

C. STOP button
It STOPS the current process and switch to next
process (e.g. Stop "Vacuum" process & switch to
"Seal" process).
D. Digital display
1. Shows the remaining time of the processes
that's being executed (VACUUM TIME, SEAL
TIME and COOLING).
2. When the vacuum and sealing process is fin-
ished and the lid (1) is still closed the display
will show "CLO".
E. Light indicators (VACUUM TIME / SEALING / GAS
/ COOLING)
Important: "GAS" function is not available for
this model

Accessories

a. Wrench (1x)
b. Screw driver (1x)
c. Empty bottle with nozzle (1x)
Adding and draining vacuum pump oil
Add oil to the pump if the following situations occur.
EN
Important! Make sure the pump oil is above MIN
marking and check regularly.
1. Before first use, the pump needs to be filled with
oil (Supplied).
2. When the oil level is below the MIN marking.
3. When the performance of the machine deteri-
orates.
4. Drain out and re-fill the pump with oil every six
months.
A) Adding oil procedures
• Use the screw driver (supplied) to loosen the
screws (8) of the rear cover (6), remove the cover
to expose the pump.
• Twist off the screw cap anti-clockwise using a
tool (not included).
• Add pump oil using the oil bottle (supplied) until
the oil level is above the MIN marking.
• Tighten the screw cap clockwise using a tool (not
included).
• Reinstalling the glass cover (6) by fixing the
screws (8) using a screw driver (supplied).
6
1. With the lid (1) open, the light indicator will
light up blue, press the
time of the corresponding process.
2. During each of the processes, the correspond-
ing light indicator is blinking to show which
part of the process is active.
F. Vacuum gauge
This gauge shows the pressure level inside the
vacuum chamber.
d. A bottle of pump oil (Volume: 300ml) (1x)
Note: Vacuum bag is not included.
B) Draining procedures
• Take a collection container and place it beneath
the oil draining port which is covered by the hex
cap screw.
• Loosen the hex cap screw anti-clockwise by us-
ing the wrench (supplied).
• After all the oil is drained, screw the cap back on
clockwise and tighten it.
• Reinstalling the lower glass cover (6) by fixing the
screws using a screw driver (supplied).
or to adjust the