BORETTI BIK-65 Notice D'emploi page 69

V) First step : cancel the existing configuration
1) Press the touch n°2 and hold down
2) The symbol [ - ] will appear on each display
3) With your other hand, press successively and quickly (less than 2s) on each [ - ] display.
Begin from the front right side and turn contrary clockwise, as described on the picture
(from a to d). (A double "beep" means an error occured. If so, start again from item 1).
4) Remove your fingers from the touch control, then push again on touch 1 for a few seconds,
until blinking [ E ] symbols appear.
5) Wait until [ E ] symbols stop blinking.
6) After a few seconds, [ E ] are automatically transformed in [ C ]. The existing setup has been
cancelled.
VI) Second step : new setup
1) Take a ferromagnetic pot with a minimum diameter of 16 cm
2) Select a cooking zone by pushing on the corresponding [ C ] display
3) Place the pot on the area to be set
4) Wait until the [ C ] display becomes a [ - ]. The selected cooking zone is now configured.
5) Follow the same procedure for each cooking zone with a [ C ] display.
6) All the cooking zones are configured once all the displays are turned off.
Please use the same pot for the whole procedure.
Never put several pots together on the zones during the setup-process.
• If [ E 4 ] displaying remains, please call the customer care
The hob or the cooking zone doesn't start-up :
• The hob could badly connected on the elec-
trical network. Check the connection.
• The protection fuse might have cut-off the
power. Check the fuse.
• The lock for the control might be activated.
Unlock the control.
• The touch control might be covered with
grease or water. Clean the touch control.
• An object is put on a key. Remove the ob-
ject.
The control panel displays [ U ] :
• There is no pan on the cooking zone.
• The pan is not compatible with induction.
• The bottom diameter of the pan is too
small.
The control panel displays [ C ] or [ E ] :
• Call the After-sales Service.
One or all cooking zone cut-off :
• The safety system functioned.
• You forgot to cut-off the cooking zone for a
long time.
• One or more sensitive keys are covered.
• The pan is empty and its bottom overhea-
ted.
• The hob also has an automatic reduction of
power level and breaking Automatic overhe-
ating
Continuous ventilation after cutting off the hob :
• This is not a failure, the fan continuous to
protect the electronic device.
• The fan cooling stops automatically.
The automatic cooking system doesn't start-up :
• The cooking zone is still hot [ H ].
• The highest power level is set [ 9 ].
NL
FR
D
EN
69