Floor Fixation - Thetford Marine TECMA X-light Manuel D'emploi Et D'installation

Operation | Installation |Service manual
Manuale di utilizzo | Installazione | Manutenzione
X-light | Privilege | Evolution | Breeze | E-Breeze | Silence Plus 2G | Elegance 2G
 In the case of non-centralized systems (sea water) with toilet installed below the
waterline, make sure the space to install the safety valve ventilation necessary
authorization and discharge at a sufficiently higher proportion to it.
 all the FLEXI LINE 2G SHORT versions self-contain all components
internally. It is no longer required to verify the space under the
usual installation step.
 The EVOLUTION model installation requires to install a
vertical fixing plate (not provided) or to suitably secure
the load on the bulkhead.

3.2 Floor fixation

The floor fixation of each head of Flexi Line and Design is using nylon brackets with side screws and
floor anchors (excluding Xlight and Evolution with special mounting kit).
Each toilet is provided with a template with the measures for drilling to the floor. In the specific case
of the new Flexi 2G line (excluding Elegance CUT), the template reverse side is a scaled template to
easily locate the exact location for drilling to the floor.
The installation of the Flexi 2G line is completed in a few steps as described below:
• Place the template against the wall in a central position to the final position of the WC
• Drill the floor in the drilling points scored in scale on the template for all Flexi 2G models
(except Elegance CUT)
• Fasten the screws to the brackets and place the toilet.
• Secure with the side fastening screws. Horizontal screw tightening must be made with a
maximum torque of 2.5 Nm.
Thetfordmarine.com TECMA S.r.l. | Via Flaminia | Loc Castel delle Formiche | 05030 Otricoli (TR) | Italy
MACERATOR TOILETS
TOILET MACERATRICI
55
Rev. 1 | 2018