EUROM 35.153.8 Manuel D'utilisation page 16


The device will retain the temperature setting by switching itself on and off
automatically.

To switch the E-convect LCD in control off, you turn the switch off (O); the light and
the display goes out. Remove the plug from the socket.
Remote Control
The E-Convect LCD in control can also be operated with the
included remote control. It also includes a timer function.

Push the plug in the wall socket.

Switch the switch (6) on (I): the light comes on and the
display flashes fleetingly on the last set temperature and
then indicates the room temperature. You can now use the
remote control.

To set the temperature, press on the 'heating' button. The
– (down) and + (up) buttons now work as the ▼ and ▲
keys on the device.

To set the timer, (while the device is working) press on the 'Timer' key, then you set
the hours with the + and – buttons (max. 24): the display fleetingly shows the set
number of hours and will repeat this intermittently. The heater switches itself off after
the selected number of hours.

You can set the device on standby at any stage by using the 'power' button: the
display switches off, the switch globe continues burning. You can now also switch on
the device with the power button.

To switch off the E-convect LCD in control, switch off the (O) switch; the globe and
the display switches off. Remove the plug from the power point.
Safety feature
In case of internal overheating, the overheating safeguard will switch the heater off.
This may occur if the heater cannot give off enough heat or if it cannot draw in enough
fresh air. As mentioned above, this is generally caused by (partially) covering the heater,
or installing the heater too close to a wall or something similar. In case of overheating,
switch off the heater and unplug. Give the heater time to cool down, remove the source
of the overheating and use as normal. If the problem persists or if you have not been
able to trace the source of the overheating, turn the heater off immediately and unplug.
Contact a servicing point to have the heater repaired.
Cleaning and Maintenance
Keep the heater clean. Switch off the heater, remove the plug from the socket and allow
the heater to cool down before cleaning or carrying out maintenance work.
 Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use
aggressive soaps, sprays, cleaners or abrasives, waxes, polishes or chemical
solutions!
 If you want to clean away the E-convect LCD in control at the end of the season,
store it, if possible in the original packaging, upright in a cool, dry and dust-free place.
16