Télécharger Imprimer la page

EUROM 35.153.8 Manuel D'utilisation page 15

Masquer les pouces Voir aussi pour 35.153.8:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Description, Composition and Installation
What is unique about the E-convect LCD in control, is that it can be painted. You can
paint the E-convect LCD in control in any colour you wish, with any water resistant paint.
Do not paint the control panel with the switch and remove the plug from the socket
before you start painting. Allow the panel to dry before using it again!
Remove all packaging material and keep out of reach of children.
You will find:
After removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance, but
contact your vendor for inspection or replacement.
Do not use the heater before it has been installed in accordance with the following
Free-standing:
Secure the feet supplied to the underside of the radiator (see diagram):
Place both feet on the ground, ± 50 cm. apart, screws to
the back
Slide the heating panel into the slot of the feet, so the
panel sticks out ± 5 cm on each side. The switch is at the
top right rear (see fig. on front of this booklet).
Secure both screws and thereby clamp the panel in the
feet.
Your E-convect LCD in control is ready to use.
Use and Working
Make sure the heater is not damaged.
Insert the plug in the socket
Turn the switch (6) on (I): the light will turn on and the display flashes fleetingly on
the last set temperature and then displays the room temperature.
If you press the up/down key (7&8), the temperature setting will flash 5x on the
display. You can adjust the temperature setting by pressing the up/down key while it
is flashing. With each key press, the temperature will be increased
decreased (▼) by one degree. If you set the temperature higher than the room
temperature, the heater will operate until the set temperature is reached.
- the heating panel
- foot (2x)
instructions!
1 Heatpanel
2 Control panel
3 Base
Control panel:
4 Reception point remote
control
5 Display
6 ON/OFF switch & pilot light
7&8 Up/down key
9 Timer bulb
15
(▲) or

Publicité

loading

Ce manuel est également adapté pour:

E-convect lcd in control