Britax BOB Gear ALTERRAIN PRO Guide De L'utilisateur page 5

BOB Gear
Rear Wheel Removal
1� Unlock Parking Brake
Prior to removing the rear wheels,
position the parking brake in the
unlocked position.
2� Remove Wheel
Raise the wheel a few inches off
the ground, (A)pull the release
lever, and (B)pull the wheel out
of the rear wheel attachment
bracket. Repeat for the other side.
Front Wheel Installation
1� Remove Through Axle
From Front Wheel
Unscrew the tension adjusting
nut from the through axle from
the front wheel.
Tension Adjusting Nut
2� Rotate Front Fork
Into Jog Mode
Rotate the front fork until it locks
into jog mode. See page 10.
6
3� Insert Front Wheel
When facing the front of the
stroller, insert the wheel between
the fork and align the wheel hub
with holes in the fork blades.
4� Insert Through Axle
Insert the through axle into the
fork and through the wheel hub,
then install the tension adjusting
nut to the opposite side.
5� Tighten Tension Adjusting Nut
With the quick release lever in
the FULLY OPEN position, hand
tighten the tension adjusting nut
until secure.
Tension Adjusting Nut
6� Close Quick Release Lever
Lift up on the quick release lever
to lock into the FULLY CLOSED
position. When properly closed,
the quick release lever will be
parallel to the fork blade and
pointing up.
Fork Blade
Fully Closed
Fully Open
NOTE: It takes considerable
force to securely close the quick
release lever. If you are able
to completely close the quick
release lever without wrapping
your fingers around the fork blade
and the quick release lever does
not leave a visible imprint in the
palm of your hand, or the quick
release lever spins freely on the
through axle, the tension is not
adequate. Return the lever to the
FULLY OPEN position and turn
the tension adjusting nut a quarter
turn clockwise, then repeat the
closing process.
If the quick release lever will
not lift into the FULLY CLOSED
position, return the lever to the
FULLY OPEN position and turn
the tension adjusting nut a quarter
turn counterclockwise. Repeat the
closing process.
ALTERRAIN PRO User Guide
Front Wheel Removal
1� Open Quick Release Lever
Move the wheel's quick release
lever from the locked or FULLY
CLOSED position to the FULLY
OPEN position.
2� Remove Through Axle
Loosen the tension adjusting nut
and remove the through axle from
the front wheel and fork.
3� Remove Front Wheel
Raise the front wheel a few inches
off ground and tap the top of the
wheel with the palm of your hand
to knock the wheel out of the
front fork.
Canopy Installation
1� Open Canopy Lock
Slide lock open on each
side of the canopy.
Close
Open
7