Wheel Installation - Yamaha Motor Ultramatic GRIZZLY 660 Manuel Du Propriétaire

1. Arrow mark
1. Flèche
1. Marca en forma
1. Tapered nut
1. Écrou conique
1. Tuerca cónica

Wheel installation

1. Install the wheel and the nuts.
NOTE:
_
G
Tapered nuts are used for both the front and
rear wheels. Install the nut with its tapered
side towards the wheel.
G
The arrow mark
ward the rotating direction of the wheel.
2. Lower the ATV so that the wheel is on the
ground.
3. Tighten the wheel nuts to the specified
torque.
Wheel nut torque:
Front: 55 Nm (5.5 m·kgf)
Rear: 55 Nm (5.5 m·kgf)
8-115
EBU01121
on the tire must point to-