Specific Instructions - Simu 5128061A Notice Originale

1.2 CONNECTIONS
WARNING!
- Do not allow children to play with fixed control devices. Keep remote controls out of reach of children.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning the use of the appliance by a person responsible for their safety.
1.3 SCRAPPING
Materials must be disposed of in accordance with the regulations in force. There are no particular hazards
or risks involved in scrapping the product. For the purpose of recycling, segregate the materials based on
their type (electrical parts - copper - aluminium - plastic - etc.).
Anything that is not explicitly provided for in the installation manual is not allowed. The proper
operation of the device can only be guaranteed if the information given is complied with. The
Manufacturer shall not be answerable for damage caused by failure to comply with the instructions
given herein. While we will not alter the product's essential features, the Manufacturer reserves
the right, at any time, to make those changes deemed opportune to improve the product from a
technical, design or commercial point of view, and will not be required to update this publication
accordingly.

SPECIFIC INSTRUCTIONS

- The radio module must only be used when screwed into the metal unit.
- Do not close the door of the unit while the curtain is moving.
- If the clutch is activated for the motor while the power is disconnected or if the power supply is
disconnected for over 30 seconds, the next radio command authorised will only be to raise the curtain
to the high stop points.
- When using a door-bottom locking system, be sure to unlock the door before operating the control.
SCOPE
434 MHz (433.05 - 434.79 MHz)
- 20°C / + 70°C
60 s. max.
53 x 35 x 11 mm
Li - 3 V DC - CR 2430
The veoHz control unit is designed to control only SIMU CENTRIS veoHz motors. Any other use is
prohibited and excludes SIMU from any liability and also nullifies the warranty, as does failure to follow the
instructions in this manual. This manual is intended to provide the instructions for installing and using an
additional command point. For installing the first command point of a CENTRIS veoHz motor, refer to the
motor manual (operation to be carried out by a professional).
SIMU hereby declares that this product conforms to the essential requirements and other relevant provisions of
RED Directive 2014/53/EU. A declaration of conformity is available at www.simu.com
EN-
6/ 3 6
ERP < 10 mW
Class III
IP 54