Simu 5128061A Notice Originale page 7

1
INSTALLATION
The unit must be installed vertically:
Vertically Horizontally
Installation of the declutching system:
Fit the handle.
①
Position the tensioner on the cable.
②
Position the tensioner in the handle.
③
Tighten the declutching cable by hand until you feel resistance without disengaging the motor.
④
Tighten the M4 screw of the cable clamp to the torque of 3.2 Nm.
⑤
After making 3 releases, take up the play created using the tensioner nuts, without disengaging the motor.
⑥
Cut the declutching cable 2 cm from the tensioner.
⑦
i
If necessary, you can tighten the declutching cable again by repeating step
②
①
2
PROGRAMMING THE RADIO MODULE ON AN EXISTING INSTALLATION
Transmitter already
programmed
PROG 3 s.
1
① From the individual command transmitter which is already programmed, open the receiver's memory: Press the PROG
button of the transmitter for about 3 seconds —> The motor responds with a "short rotation".
② Then validate the operation from the new transmitter to be programmed: Press the PROG button of the new transmitter
for about 1 second —> The motor confirms the setting with a "short rotation".
- To delete a transmitter from the motor's memory: perform operation ① with a programmed individual transmitter and the
operation ② with the transmitter to be deleted.
3
ATTACHING THE RADIO MODULE
Screw the module into the unit using the supplied screws, with a maximum torque of 0.9 Nm
1 - Mark the position of the holes using the SCALE TEMPLATE (page 33) and drill.
2 - Pass the declutching cable through the hole  provided for this purpose. Make
sure that the flexible sleeve rests against the bottom of the unit.
3 - Attach the declutching unit to the wall with appropriate fasteners through the
holes .
③
PROG 1 s.
2
.
⑥
④
⑤
⑥
New transmitter

⑦
2 cm
Note: The number of
programmable transmitters
per installation is limited to 12.
EN-

7/3 6