Command Mode; Replacing The Battery - Simu 5128061A Notice Originale

4

COMMAND MODE

MODE 1:
press and hold
inactive
press and hold
MODE 1: command by press and hold to raise and lower.
MODE 2: command by pulse to raise and by press and hold to lower.
5
SAVING / PARTIAL OPENING
1-
0,5 s.
a-
This function is available only for "MODE 2" (raising using pulse) and only for the up movement.
1- CHECK if the default "partial opening" position suits you.
a- To do this, position the curtain in the lower position.
b- Press the ● stop button for 0.5 second.
c- The curtain returns to its "partial opening" position.
2- MODIFY THE "PARTIAL OPENING" POSITION if the default position does not suit you.
a- To do this, position the curtain in the desired "partial opening" position.
b- Press the ● stop button for 6 seconds —> The motor confirms the setting with a "short rotation".
c- The new partial opening position has been saved.
6

REPLACING THE BATTERY

Low battery: when the transmitter LED flashes very rapidly, and the motor stops after 3 seconds, you must replace the
battery; otherwise the curtain cannot be operated. This maintenance operation must be carried out after 2 years, or before,
depending on how frequently it is used.
7
USING THE CURTAIN MANUALLY
EN-
8/ 3 6
MODE 2:
pulse
STOP / partial opening
press and hold
(MODE 2 ONLY)
b- c-
+
For your own safety and that of other people,
according to EN 12453, your installer has chosen a
control mode that corresponds to the configuration of
your installation.
2-
6 s.
a- b-
CR 2430 type 3V lithium battery. Do not recharge.
Please dispose of your device, batteries
or used batteries separately at a
collection point for recycling.
Keep people away from the curtain before
handling.
1 - Open the unit
2 - Pull on the handle
3 - Operate the curtain by hand to the desired
position while keeping the handle actuated
4 - Push back the handle
5 - Close the unit
OK
c-