EUROM 1600 Manuel D'utilisation page 25

insert the plug into the socket.
Vacuuming
 Make sure that the collection bag is attached correctly in its place. Hold the handgrip of
the machine and start it by pushing the ON/OFF switch on the handgrip to ON (I is
pushed in).
Blowing using the blow mouth on the machine
Remove the collection bag from the machine.
 Slide the connection at the backside of the blow hose over the outlet with its recesses
entirely over the projections (F).
 Rotate the connection clockwise as far as possible to affix the hose onto the machine
(G).
 Start the machine by pushing the ON/OFF switch on the handgrip to ON (I is pushed in).
Now the air blows out of the blow mouth (H).
Blowing using the blow hose and perhaps the extension tubes
Usually, this method is used for locations, corners, etc. that are difficult to reach. The user
can blow in any required directions.
 Remove the collection bag from the machine.
 Slide the connection at the backside of the blow hose over the outlet with its recesses
entirely over the projections (F).
 Rotate the connection clockwise as far as possible to affix the hose onto the machine
(G).

Pull the blow hose out of the blow mouth (I). If necessary, you can extend the blow hose
using one or two extension tubes (J): these can only slide over one another in one way
and are self-locking.
 Hold the end of the blow hose or extension tube(s) in your hand and start the machine by
pushing the ON/OFF switch on the handgrip to ON (I is pushed in). Now the air blows out
of the blow hose / extension tube(s) (K).
Adjusting the suction height
25