Caution; Description; Placing Into Operation; Equipotential Bonding - Weller MPR 80 Mode D'emploi

English
Thank you for placing your trust in our company by purcha-
sing the Weller mirco-solderer MPR 80. Production was
based on stringent quality requirements which guarantee the
perfect operation of the device.

1. Caution!

Please read these Operating Instructions and the attached
Safety Information carefully prior to initial operation. Failure
to observe the safety regulations results in a risk to life and
limb.
The manufacturer shall not be liable for damage resulting
from misuse of the machine or unauthorised alterations.
Safety Informations
● Always place the soldering iron in the original holder.
● Remove all inflammable objects from the proximity of the
hot soldering tool.
● Use suitable protective clothing. Risk of burns from liquid
solder.
● Never leave the hot soldering iron unsupervised.
● Never work on voltage-carrying parts.

2. Description

The Weller micro-soldering device MPR 80 features ergono-
mic design in addition to a movable heating element. Thanks
to the highly efficient 80 W heating element, the soldering
temperature is reached precisely and with lightning speed.
The angle of the movable heating element can be modified by
up to 40° by releasing the retention screw (5). With its slen-
der form and simple changing of the soldering tip, this
soldering device is suitable for universal aplication, from
extremely fine soldering operations to work with increased
heat demand.
With an integrated grounding connector, there is the
possibility for a grounding of the solder bit if required. The
anti-static handle and cables mean that the soldering iron
satisfies all requirements of the ESD safety.

3. placing into Operation

Place the soldering iron in the safety holder. Remove all
flammable articles from around the soldering iron. Plug and
lock the connector (7) into the supply unit. Set the required
Specifications
Connecting voltage:
Power:
Warm up time:
Max. temperature:
Can be connected to any 80 W power supply unit with electronic control.
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
5
temperature on the supply unit. Wet the soldering bit with
solder once it has heated up.

4. Equipotential Bonding

If required, an grounding of the soldering bit can be created
via the supply unit. The connection possibilities for grounding
are described in the instructions for the supply unit.

5. Information for Operation

Changing soldering bits
- hold soldering iron horizontal.
- loosen the knurled nut around the bit-sleeve (2).
- pull the bit-sleeve (2) towards the front.
- the soldering bit now sits loosely in the sleeve.
Caution, risk of burns!
Even after switch off or removal, the soldering tip needs
some time to cool down.
Do not place the hot soldering iron bit or knife point on the
cleaning sponge or plastic surfaces.
When using a number of different solder bits, it is recommen-
ded that the soldering bit and sleeve are used together as a
quick change system.
Anti-static plastics containing conducting fillers are used to
prevent static charge build-up. This also means that the
insulating properties of the plastic are reduced. No work
should be undertaken on articles which are live, or at high
voltage.
The instructions for the use of the supply unit are valid in
addition to these here.
For soldering work with very low heat requirements, the use
of a switching holder is recommended.
The low heat requirements can reduce the reliability of the
setback function.

6. Accessories

Soldering bits figure LT-Tips see page 21 - 25.
Subject to technical change without notice!
See the updated operating instructions at www.weller.eu.
24V
80 W
approx. 10 sec. (50°C - 350 °C)
450 °C