Caution; Control Unit - Weller WSD 81 Mode D'emploi

Thank you for placing your trust in our company by purcha-
sing the WELLER soldering stations WSD 81. Production was
based on stringent quality requirements which guarantee the
perfect operation of the device.

1. Caution!

Please read these Operating Instructions and the attached
safety information carefully prior to initial operation. Failure
to observe the safety regulations results in a risk to life and
limb.
The manufacturer shall not be liable for damage resulting
from misuse of the machine or unauthorised alterations.
The WELLER soldering stations WSD 81 corresponds to the
EC Declaration of Conformity in accordance with the basic
safety requirements of Directives 2004/108/EC, 2006/95/EC
and 2011/65/EU.
2. Description

2.1 Control unit

The microprocessor-controlled soldering station
WSD 81 is part of a family of units that has been developed
for industrial production technology and for the service and
laboratory sector. The digital control electronics and a high-
quality sensor and heat exchange system in the soldering
tool guarantee precise temperature control at the soldering
tip. The highest degree of temperature precision and optimal
dynamic thermal behavior under load conditions is obtained
by the quick and accurate recording of measured values in a
closed control circuit. The soldering tools themselves are
recognized automatically by the WSD 81 and the corre spon-
ding control parameters are assigned accordingly.
Various equipotenzial bonding possibilities for the soldering
iron tip, zero power switch and antistatic design of control
unit and iron complete the high quality standard. The possi-
bility of connecting an external input unit further increases
the variety of functions of this soldering station. With the
optional input units WCB 1 and WCB 2 it is possible to imple-
ment time functions, locking functions, etc. Integrated tem-
perature gauge and PC interface are included in the extended
scope of the input unit WCB 2.
The temperature is set in a range between 50°C and 450°C
(150°F and 850°F) using two buttons (up/down). The setpo-
int and actual value are displayed digitally. A blinking red LED
in the display signals that the preset temperature has been
reached – this serves as a optical regulator. Constant illumi-
nation means that the system is heating up.
2.2 Soldering irons
WP 80: The soldering iron WP 80 / WSP 80 is
WSP 80 characterized by its capacity for reaching the
soldering temperature quickly and precisely.
Its slim design and heating power of 80 watts
makes universal usage possible - from
extremely fine to high-temperature soldering
work. Work can be continued immediately
after switching soldering tips, since the
temperature is reached again quickly.
LR 82: High-performance 80 watt soldering iron for
soldering work with high heat requirements.
The soldering tip is attached by a bayonet
catch to ensure correct position when using
different tips.
MPR 80: The Weller Peritronic MPR 80 soldering iron
has an adjustable working angle of 40° to
enable an individually ergonomic soldering
process. The 80-watt power and slim design
makes this soldering iron suitable for fine
soldering work.
LR 21: Our "standard" soldering iron. With a power
of 50 watts and a wide spectrum of soldering
tips (ET series) this soldering iron can be used
anywhere in the electronics sector.
WMP: Due to its handy design, the Weller WMP
micro soldering iron is suitable for work on
professional SMD electronics. A short
distance between the handle and the
soldering tip ensures ergonomic handling of
the 65 W soldering iron when performing the
finest of soldering tasks.
WTA 50: The unsoldering tweezers WTA 50 were
specially designed for unsoldering SMD
components. Two heating elements
(2 x 25 watts), each with its own temperature
sensor, ensure constant temperatures at both
ends.
See "Accessories" for additional tools.
English
13