Caution; Description; Technical Data; Placing Into Operation - Weller HAP 1 Mode D'emploi

Thank you for buying the Weller HAP 1. The apparatus has
been subjected in the production process to the most
stringent quality requirements, which will ensure
faultless apparatus operation.

1. Caution

Please read these Operating Instructions and the Safety
Information carefully prior to initial operation of the
apparatus. Failure to observe the safety regulations
results in a risk to life and limb.
The manufacturer shall not be liable for damage or injury
resulting from use that deviates from these Operating
Instructions and from unauthorised modifications.
Safety Informations
● Always place the soldering iron in the original holder.
● Remove all inflammable objects from the proximity of the
hot soldering tool.
● Use suitable protective clothing. Risk of burns from liquid
solder.
● Never leave the hot soldering iron unsupervised.
Do not point the hot air soldering tool at persons or
flammable objects
● Never work on voltage-carrying parts.
● In case of usage of nitrogen, ensure adequate ventilation
(Only on units with external compressed air supply)

2. Description

100 W hot air soldering tool with integrated finger switch,
suitable for soldering and desoldering surface mounted
components. A wide range of nozzles makes the tool of
universal application.
The air flow is controlled using the finger switch integrated
in the handle. The hot air flowing out of the soldering tool is
free of static charges. Hose and handle are of anti-static
design. The temperature-regulated hot air can be set to
between 50°C and 550°C using the control unit employed.

Technical Data:

Heater rating:
Heater voltage:
Max. air flow rate:
Temperature range:
Precision:
100 W
24 V AC
10 l / min.
50°C – 550°C
+/- 30 °C
3. Placing in Operation
Ensure that the control unit is switched off. Place the hot air
pencil in the safety stand. Plug the electrical connector into
the 7-pole connecting socket on the control unit and lock.
Slide the hose onto the „AIR" nipple on the control unit.
Switch on unit and set temperature and air flow rate.

4. Potential balance

The hot air soldering tool is equipped with an equipotential
bonding wire that can be configured as per the operating
instructions for the control unit used.
5. Soldering Notes
The thread depth is max. 5 mm (0.2"). A longer thread
will cause irreparable damage to the heater element
Replacement hot air tools are supplied adjusted and can be
connected without further adjustment.
To check the temperature of the hot air, it is recommended to
use a special measuring nozzle (T0058727808) through
which a sheathed thermocouple ø 0.5mm can be connected.
The operating instructions for the control unit used are
also applicable in addition to these operating
instructions

6. Items Supplied

Hot Gas Pencil 24 V, 100 W
WDH 30 Safety rest
R04 Nozzle 1,2 mm ø
Operating Instructions
Subject to technical change without notice!
See the updated operating instructions at
www.weller-tools.com.
English
T005 27 115 99
T005 15 152 99
T005 87 278 21
5