EUROM MM3500 Manuel D'instructions page 32

7. As soon as the motor is warm, put the choke lever
back to the OPEN position.
8. To warm up, let the motor run for approx. three
minutes and then connect the power-consuming
equipment. The voltage is regulated by means of
the number of motor revolutions; this is set
correctly in the factory. Adjusting this yourself will
invalidate the warranty!
CAUTION! When connecting the equipment, make sure that you do not exceed the
total maximum capacity of the generator. Take into account the peak
current consumption! Furthermore, do not exceed the maximum output
(Amp.) of each socket.
CAUTION! During the first two to three operating hours (the run-in period), do not
connect any high power-consuming equipment.
Stopping the generator
1. Disconnect all connected equipment.
2. Let the generator run idle for two additional minutes.
3. Then set the motor switch to the OFF stand (press O).
4. Supervise that the generator has stopped operating completely.
5. Close the fuel cock if you want to clear away or move the generator.
6. If you want to cover the generator, then wait until it has cooled down
completely.
CAUTION! In case of an emergency, switch OFF the motor immediately (press O).
32