Corghi A 2030 Manuel D'utilisation page 121

Turntable does not rotate in either direction
Control faulty.
➥ Replace the inverter.
➥ Check the microswitches of the pedal unit (only for motor inverter)
➥ Replace the inverter board (only for motor inverter).
Reduction gear clamped.
➥ Replace the reduction gear.
Gear unit noisy. The turntable makes a 1/3 of a turn and then stops
Reduction gear is seizing.
➥ Replace the reduction gear.
Turntable stops under strain,
but the motor is running
Insufficient belt tension.
➥ Adjust belt tension (fig.41) or replace it.
Turntable fails to clamp rims
Faulty turntable cylinder.
➥ Replace the turntable cylinder.
41
Tips of locking wedges are worn.
➥ Replace the locking wedges.
Control pedals do not return to their position
Pedal return spring broken.
➥ Replace the spring.
Bead breaker cylinder lacks force, fails to break beads and leaks air
Silencer plugged.
➥ Replace the silencer
Cylinder seals worn.
➥ Replace the seals.
➥ Replace the bead breaker cylinder.
After clamping, the tool head does not rise or rises too far
from rim
Clamping plate not adjusted.
➥ Adjust the plate.
EN
When the pole tilts back, the vertical and horizontal arms slide to
their limit stop
Faulty clamping plate.
➥ Replace the plate.
A 2030 - A 2025 - A 2022 - A 2018 - A 224 A - A 224 Operator's manual 121