Technical Specifications - brennenstuhl ML CA 110 M DE 4113 Mode D'emploi

Masquer les pouces Voir aussi pour ML CA 110 M DE 4113:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
Rechargeable LED work lamp 10 W
D
ML CA 110 M DE 4113

TECHNICAL sPECIFICATIONs:

Type description
Output:
Rechargeable batteries:
Operating time:
Charging time:
USB outlet:
Protection class:
Protection class:
Temperature range:
sAFETy NOTEs:
• Please read the operating instructions carefully prior to use and do not throw them away.
• Prior to every use, check the lamp and power adapter for damage.
Never use the lamp or power adapter if there is any damage.
In this case, please contact an electrician or write to the service address provided by
the manufacturer.
Non-compliance may result in risk to life due to electrical shock!
• Never open the device.
The lamp does not contain any components that require maintenance.
The LEDs cannot be replaced.
• Do not use the work lamp in explosive environments in which flammable liquids,
gases or dusts are present. Risk to life!
• The lamp is protected against spray water.
Never immerse the lamp in water or other liquids.
Risk of explosion and fire!
• Keep children away from the lamp.
Children are unable to assess the dangers of electric current.
• Use only the recommended power supply unit to charge the batteries.
Using other power supply units can damage the batteries or result in an explosion!
• Switch the lamp off before you clean it. Clean the lamp regularly with a dry, lint-free cloth.
To remove dirt, a damp cloth can be used. Do not use any solvents, caustic cleaning agents, etc.
• Do not look directly at the light to avoid being blinded.
sET-UP/ MOUNTNG THE LAMP:
Using the multi-level, folding bracket, the tilt angle of the lamp can be adjusted as needed.
The lamp can be hung up on a hook using the bracket.
16P146 Akku LED Arbeitsstrahler_170327.indd 5
ML CA 110 M DE 4113
10 W
Li-Ion 3.7 V, 4400 mAh (cannot be replaced)
approx. 3 h (100 %) or 6 h (50 %)
depends on power supply unit, approx. 4.75 hours,
at max. charging current 1A
5 V, max. 1 A
IP 54 (onlt if the transparent cover is closed)
III
-10 °C – +40 °C
5
28.03.17 11:06

Publicité

Table des Matières
loading

Table des Matières