Troubleshooting - Fimap FE A65.2 DP Manuel D'utilisation Et D'entretien

8. Remove the suction pipe (11) from the suction nozzle (12) present in the collection shaft, press button
(13) to release the latch (Fig. 7) before pulling the suction pipe.
7
6
5
4
9. Clean the inside of the suction pipe with a jet of compressed air, if necessary remove any obstructions.
10. Unscrew the nozzle Stop Ring (14) (Fig. 8).
11. Remove the Nebulizer nozzle (15) and clean it (Fig. 9).
12. Refit the nebulizing nozzle (15) on the appliance and secure it using the nozzle stop ring (14).
13. Clean the inside of the accessory suction chamber with a jet of compressed air, if necessary remove
any obstructions.
12
13
11 14
7 8
14. Remove the detergent solution tank (16) from the support (Fig. 10), rinse the inside with a jet of water.
15. Clean the suction filter (17) of the detergent solution (Fig. 11).
16. Refit the whole.
16
17
10 11
This chapter shows the most recurring problems related to the use of the appliance. If you are unable
to solve the problems with the following information, please contact the service centre nearest to you.
10
8
9
6
DOES NOT TURN ON
15
9
DOES NOT SUCK THE
INSUFFICIENT WORK
35

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
The main switch
activated.
The plug on the power cord
of the appliance, which is not
correctly connected to the
mains socket.
THE APPLIANCE
The electronic specifications
of the appliance
correspond with the electronic
specifications of the power
supply network.
The damaged power cord.
The current
damaged.
The level of dirty liquid present
in the collection drum has
THE APPLIANCE
reached the critical level.
DETERGENT
The suction tube is clogged or
damaged.
Suction hood not positioned
correctly.
The lower suction hood gasket
does not adhere properly to the
collection drum.
The suction
correctly connected to the
nozzle in the collection drum.
The suction
correctly connected to the
INSUFFICIENT
extension tube.
SUCTION
The extension tube is not
correctly connected to the
suction accessory you are
using.
There are impurities
obstruct the suction circuit
(suction pipe, extension tube,
suction accessory).
There are impurities
obstruct the suction filters.
Poor detergent leakage
SOLUTION
is not Press the main switch.
Connect the plug in the power
cord of the appliance to the
mains socket.
Check whether the technical
do not
data on the rating plate
correspond to the data of the
power supply.
Contact a specialized
technician urgently.
line fuse is
Replace the current line fuse.
Empty the collecting drum.
Check the status of the suction
pipe
Remove the suction hood and
reposition it correctly.
Clean the lower suction hood
gasket and the upper edge of
the collecting drum.
hose is not Connect the suction pipe
correctly to the nozzle in the
collecting tank.
tube is not
Connect the suction pipe
correctly to the extension tube.
Collegare il tubo prolunga in
modo corretto all'accessorio
aspirante che si sta utilizzando.
that
Remove the impurities present
in the suction circuit
that emove the impurities present in
the suction filters.
Fill the detergent tank with
another cleaning solution.
Clean the nebulizer nozzle.