Stanley FATMAX FMEG210 Mode D'emploi page 5

@
Additional power tool safety warnings
d. Store idle power tools out of the reach of children and
do not allow persons unfamiliar with the power tool or
these instructions to operate the power tool.
tools are dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
f. Keep cutting tools sharp and clean. Properly
g. Use the power tool, accessories and tool bits etc. in
accordance with these instructions, taking into
account the working conditions and the work to be
performed.
from those intended could result in a hazardous situation.
5. Service
person using only identical replacement parts.
Warning!
Abrasive Cutting-Off Operations:
This power tool is intended to function as a grinder,
sander, wire brush, polisher or cut-off tool. Read all
safety warnings, instructions, illustrations and
Operations such as polishing or cutting-off are not
recommended to be performed with this power tool.
designed and recommended by the tool manufacturer.
Just because the accessory can be attached to your
The rated speed of the accessory must be at least
tool. Accessories running faster than their rated speed
The outside diameter and the thickness of your
accessory must be within the capacity rating of your
power tool. Incorrectly sized accessories cannot be
adequately guarded or controlled.
Threaded mounting of accessories must match the
grinder spindle thread.
(Original instructions)
control.
Do not use a damaged accessory. Before each use
inspect the accessory such as abrasive wheels for
chips and cracks, backing pad for cracks, tear or
excess wear, wire brush for loose or cracked wires. If
power tool or accessory is dropped, inspect for
damage or install an undamaged accessory. After
inspecting and installing an accessory and run the
power tool at maximum no-load speed for one minute.
test time.
application, use face shield, safety goggles or safety
glasses. As appropriate, wear dust mask, hearing
protectors, gloves and workshop apron capable of
stopping small abrasive or workpiece fragments.
by your operation. Prolonged exposure to high intensity
noise may cause hearing loss.
Keep bystanders a safe distance away from work
area. Anyone entering the work area must wear
beyond immediate area of operation.
Hold power tool by insulated gripping surfaces only,
when performing an operation where the cutting
accessory may contact hidden wiring or its own cord.
Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding the
may lead to loss of control.
Position the cord clear of the spinning accessory. If
hand or arm may be pulled into the spinning accessory.
Never lay the power tool down until the accessory
has come to a complete stop.
control.
Do not run the power tool while carrying it at your
side.
ENGLISH
Accessories that do not
5