Stanley FATMAX FMEG210 Mode D'emploi page 7

operations
Safety of others
Support panels or any oversized workpiece to
minimize the risk of wheel pinching and kickback.
Residual risks
Use extra caution when making a "pocket cut" into
existing walls or other blind areas.
Do not use excessively oversized sanding disc paper.
Follow manufacturers recommendations, when
selecting sanding paper. Larger sanding paper
extending beyond the sanding pad presents a laceration
Be aware that wire bristles are thrown by the brush
even during ordinary operation.
Do not overstress the wires by applying excessive
load to the brush.
If the use of a guard is recommended for wire
brushing, do not allow any interference of the wire
wheel or brush with the guard.
forces.
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
accessories.
Vibration
Labels on tool
(Original instructions)
Impairment of hearing.
data and the declaration of conformity have been measured
used in a preliminary assessment of exposure.
Warning!
increase above the level stated.
When assessing vibration exposure to determine safety
trigger time.
on the tool:
Warning!
must read the instruction manual.
this tool.
Electrical safety
Your charger is double insulated; therefore no
mains voltage corresponds to the voltage on the
rating plate.
manufacturer or an authorised Stanley Fat Max Service
Centre in order to avoid a hazard.
ENGLISH
7