Operating Instructions - Petsafe Drinkwell Platinum D2-CA-17 Manuel D'utilisation

Operating Instructions

Important: DO NOT RUN DRY - FOR INDOOR USE ONLY. Pet Fountain will come
fully assembled and ready for use.
1. As with any electrical device, check the electrical Power Cord for any tears or
damage before use.
2. Make sure the In-line Plug is connected. When connected properly the silver tip is
not showing.
3. Remove the Housing Lid by placing your index fingers into the inset groves on either
side of the Housing Lid. Lift up. Set the Housing Lid aside.
4. Remove the Reservoir from
the Pet Fountain and check
to make sure the Intake
Tube is properly inserted
into the Pump
(Fig. 1 & 2).
5. Insert the Charcoal Filter
into the Housing. The
Charcoal Filter will fit into
the two triangular slots in the centre of the Housing. The Charcoal Filter fits narrow side
down and the black side faces the front of the Pet Fountain. The Charcoal Filter will
slide easily into place (Fig. 3).
Important: Rinse the Charcoal Filter thoroughly under cool
water before placing into the Housing. This will remove any
loose charcoal dust, which is harmless. A small amount of
charcoal dust may be released for the life of the Charcoal
Filter. This is normal and not harmful to your pet.
6. Fill the Pet Fountain with water. This includes the Bowl and
the Housing. This will prime the Pump.
7. Replace the Housing Lid and snap it into place.
Fig. 1
www.petsafe.net
Fig. 2
Fig. 3
7