Operating Instructions - Petsafe Drinkwell Mini Pet Fountain Manuel D'utilisation

OPERATING INSTRUCTIONS

DO NOT RUN DRY - FOR INDOOR USE ONLY
1) As with any electrical device, check the electrical cord for any
tears or damage before use.
2) Make sure the inline plug is fully connected. (No silver showing)
3) Remove the housing cover (lid) by placing your index fingers
into the inset grooves on either side of the lid. Lift up. Set the lid
aside.
4) Insert the charcoal filter. The filter will
fit into the two triangular slots located
on the right side of the housing.
The filter fits narrow side down and
the white side faces the front of the
fountain (as shown in Fig. 1a). The
filter will slide easily into place, but
make sure it is pushed all the way
down.
NOTE: Rinse the filter thoroughly under cool water before placing
in the fountain. This will remove any loose charcoal dust, which is
harmless. A small amount of charcoal dust may shed for the life of
the filter. This is normal and not harmful to your pet.
5) Place fountain in desired location. If placing on carpet, tile or
wood flooring use a protective mat or other durable, water
resistant surface to protect your floor from splashing or dripping
from your pet.
6) Fill the unit with water. This includes both the bowl and the filter
housing. This will prime the pump. Replace the lid.
7) Before you plug the fountain in, make sure the cord and your
hands are dry. Plug the fountain into an electrical outlet.
www.petsafe.net
Fig. 1a