Personalising Recipes - BORETTI BPC-45 Notice D'emploi

GB
Note: at any moment, if you make a mistake choosing the values and/or you want to change the settings of your
recipe, you can select
NOTE: If you are cooking with the modified parameters of a pre-set recipe, while the combimagnetron beeps at
the end of cooking, you will see:

PERSONALISING RECIPES

Once a pre-set recipe has finished, if you decide that the parameters must be changed for the results that you
want, you can change the recipe you used and save it for the next time by storing the new parameters used
(weight and cooking time).
To change the parameters of a preset recipe, do the following:
ATTENTION: certain
combimagnetron has reached the set temperature and the display shows "PRE-
HEATING FINISHED PUT IN THE DISH"
When cooking is finished the display will flash "PROGRAM FINISHED REMOVE THE
DISH" and, at the same time, the combimagnetron will beep until you press a key or
open the door.
which cancels it and allows you start over from the beginning of the procedure.
see how to save recipes in the next paragraph.
- with the + key select "YES"
- confirm with the key, the time used is displayed
- change with the + and - keys and confirm with
- change with the + and - keys and confirm with
saved POS. 1/1, and so on with a progressive number
Every time you access the "personal recipes" menu, you will fine your recipes saved in
the list of your recipes.
If there is not enough memory for saving personal recipes, the following message
appears on the display: "Insufficient memory, impossible to save".
- use the buttons to scroll through the menu and select the recipe you want to
delete.
NOTE: the names are given by default by the menu);
recipes use pre-heating,
Before saving your recipe, you must delete one
from the menu in this way:
- select the
- and then, by pressing
recipes" section where you will find the saved
recipes;
54
so put the dish
, the weight used appears
, you will see the message "Recipe
function;
go to the "personal
in when the