BORETTI BPC-45 Notice D'emploi page 44

Simple cooking commands
Thanks to state-of-the-art controls, only two touches are required to set a cooking mode: turn on the
combimagnetron and select the most suitable function for the dish you are about to cook... you choose it and
you touch it!
GB
The control suggests a temperature for each function, which you can change at any time, but if you
consider it suitable, you don't need to do anything else, the combimagnetron will start by itself in just a
few seconds!
Setting the temperature
The uses a temperature probe that is accurate to ±5 °C for the maximum reliability of the cooking temperatures
requested.
You can change the temperature at any time. After selecting the cooking function, just touch the symbols
and the setting range varies from +50 °C to MAX.
You don't need to confirm the change, the control turns on by itself after a few seconds.
Residual heat
While cooking food, the structure of the combimagnetron stores heat. This heat is kept isolated from the rest of
the kitchen thanks to generous heat insulation and certain construction techniques.
This heat is gradually dissipated over time and can still be a resource in the kitchen, if it is managed: the control
shows the internal temperature after the combimagnetron is turned off until it falls to 50 °C.
During heating, the centigrade symbol (°C) flashes
to indicate that it is heating up to reach the selected
temperature. When the temperature is reached, it beeps.
NOTE: some models may display the current temperature
in the combimagnetron until the temperature set is
reached. If you want to check the temperature set, press
any one of the keys
them to change the temperature set.
44
and, if you wish, you can use