Installation; Lifting; Mounting On Engine; Assembly Format Sae - Sincro SK225 SM Manuel D'utilisation Et De Maintenance

6. INSTALLATION

6.1 Lifting

Lift and handle the generator with suitable equipment
either on a pallet or by the lifting lugs located on the
generator in the positions indicated in the figure.
When lifting the SK225 generator use equipment
with a load bearing capacity of at least 500kg.
When lifting the SK250 generator use equipment
with a load bearing capacity of at least 1000kg.
An insuffi cient loadbearing capacity can
cause severe injury and damage.
CAUTION!
The lifting lugs on the generator have been
designed for lifting only the generator and
not the whole generating set.
CAUTION!
When lifting and handling single bearing generators they
must be kept horizontal in order to avoid, if operations
should go wrong, the rotor from slipping out and being
damaged and possibly causing severe injury.

6.2 Mounting on engine

For tightening torques refer to section 6.2.3.
For mechanical connections it is recommended to use
screws in class 8.8.

6.2.1 Assembly format SAE

Before assembly, check that the coupling
seats (both on generator and engine) are in
order and perfectly clean.
CAUTION!
• Remove the transport bracket from the generator;
• remove the protective grid (4) from the bell;
• make sure the diameter of the disk (3) corresponds
with the diameter of the seat of the fl ywheel (2);
• fi x the generator to the engine by locking the SAE bell
(1), making sure that the holes in disk and fl ywheel
are aligned;
4
1
3
2
• check that the disk is in contact with the fl ywheel;
• lock the disk into the fl ywheel;
• support the assembly on antivibration dampers
making sure that engine and generator are level;
• remount the grid, block the hooking closures (5) and
insert the cotter pin (6) paying attention to open the
anti-slip legs.
5
6
Inadequate protection and/or bad alignment
of the generator can cause injury and/or
damage to equipment.
WARNING!
4
23