Seca 684 Mode D'emploi Et Garantie page 22

Bolts and tools
The following small parts and tools are included in the supplied equipment:
• 16 galvanized M6 x 12 countersunk bolts
• 8 black covers for M6 countersunk bolts
• 6 galvanized J 6.4 crown gears
• 4 galvanized M8 x 20 oval head screws
• 4 galvanized 8.4 washers
• 8 white covers for M6 countersunk bolts
• 4 galvanized B 3.5 x 9.5 pan-head tapping screws
• 4 galvanized 6.4 washers
• 4 galvanized M6 x 20 oval head screws
• 1 SW4 hexagon wrench
• 1 SW5 hexagon wrench
• 1 size 1 Philips-head screwdriver
• 1 SW 8/10 socket wrench
• 1 SW 10 combination wrench
Assembling the scales
1. Unscrew the three nuts from the bolt
on the sides of the weighing platform.
2. Place the right element on the rear
bolt of the weighing platform.
3. Swing the side element back behind
the level support.
4. Place the side element onto the mid-
dle and front bolt of the weighing plat-
form.
5. Place the crown gear and nut onto the
middle bolt and tighten it firmly by
hand.
22