Alarms Setup; Alarms Settings - Cristec HPO-DISPLAY-R-B Manuel Utilisateur

4
6.3 A
LARMS SETUP

6.3.1 Alarms settings

5
4
5
4
3
3
3
1 : Primary software version (Battery charger)
2 : Secondary software version (Battery charger)
3 : Home (return to main page)
4 : Charger model (ex. 12V – 90A)
1
2
1 : Batt. 1 Low : under voltage alarm can be
set from 8.0V to 13.0V (from 16V to 26V
for a 24V charger)
2 : Batt. 1 High : overvoltage alarm can be set
1
from 14.0V to 16.0V (from 28V to 32V for
a 24V charger). **
3 : Home (return to main page)
2
4 : Alarm Delay : can be adjusted from 0 to 60
seconds
5 : Alarm ON/OFF : enables all alarms
including over temperature alarm which is
factory set to 50°C (available if
temperature probe connected only).
1 : Batt. E Low : under voltage alarm can be
set from 8.0V to 13.0V (from 16V to 26V
for a 24V charger)
2 : Batt. E High : overvoltage alarm can be set
1
from 14.0V to 16.0V (from 28V to 32V for
a 24V charger). **
3 : Home (return to main page)
2
4 : Batt. 2 Low : under voltage alarm can be
set from 8.0V to 13.0V (from 16V to 26V
for a 24V charger)
5 : Batt. 2 High : overvoltage alarm can be set
from 14.0V to 16.0V (from 28V to 32V for
a 24V charger). **
29