Package Contents; Description Of The Product; First Use; Charge Of The Product - Num'axes iki pulse Guide D'utilisation

Masquer les pouces Voir aussi pour iki pulse:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1

Package contents

- rechargeable collar equipped with nylon strap and short contact points
- charger
- magnetic key (magnet)
- pair of long contact points

Description of the product

Nylon strap
Red indicator light:
On/Off indicator
battery level indicator

First use

The IKI PULSE collar comes partially charged from the factory. It is necessary to fully charge the battery of your IKI PULSE
collar before the first use (duration of the 1
When the battery is charging, the red light indicator stays constantly blinking. Once the battery is fully charged, the red indicator
light goes out.

Charge of the product

To charge your product, the collar must be necessarily turned off.
To charge your product, proceed in the following way:
- Remove the protection tab located at the back of the collar (See. Diagram 2).
- Plug the charger to the receptacle at the back of the collar (See. Diagram 2).
- Then plug the line cord of the charger on an outlet.
- When the battery is charging, the red indicator light stays constantly blinking (the charge of the product lasts approximately
3 hours).
CAUTION : If your product is completely weak, the red LED will not light during the charge.
In this case, after approximately 15 minutes of charge, place for one second the magnetic key close to the orange mark located
on the front of your collar (See. Diagram1). Then, the red indicator light will start blinking to indicate you that your battery is
charging.
contact points
(short or long)
+
st
charge : from 3 to 6 hours).
- screwdriver
- neon test lamp
- user's guide
Diagram. 1
Area where the magnet is located to
or change operating mode
Gb - 13
screwdriver
Orange mark:
switch On/Off

Publicité

Table des Matières
loading

Table des Matières