Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10.
Assembly of the Neck Roll
10.1. Unfasten the chin strap (see relevant instructions).
10.2. Insert the neck roll, fasten and then close the zip (Fig.17).
10.3. Pull the front of the left cheek pad towards the inside of the helmet to release
the front button on its back (Fig.15).
10.4. Fasten the neck roll eyelet fastener (Fig.16) and refasten the left cheek pad.
10.5. Follow the same steps on the other side of the helmet.
10.6. Insert the chin strap band into the elastic loops on the strap and/or on the neck
roll (Fig.14).
WARNING
-
After disassembling or assembling the roll neck, it is necessary to check that
the chin strap is adjusted correctly (see attached label).
-
Before using the helmet, make sure that the sliding clip of the zip does not
protrude from the helmet and that it is correctly bent and housed in the corre-
sponding elastic loop between the outer shell and the polystyrene cheek pad.
11.
Disassembly of the Cheek Pads
11.1. Open the chin strap (see specific instructions) and remove the chin strap band
from the elastic loops on the strap and/or on the roll neck (Fig.14).
11.2. Pull the front of the left cheek pad towards the inside of the helmet to release
the buttons on its back (Fig.15).
11.3. Completely remove the padding of the left cheek pad from the helmet by pull-
ing the chin strap band out of the slot on the left cheek pad padding.
11.4. Repeat these steps with the right cheek pad padding.
Note: It is not necessary to remove the polystyrene cheek pads from the helmet shell.
12.
Disassembly of the Liner
12.1. Pull the back of the comfort padding towards the inside of the helmet to un-
hook the two side buttons on its back from their seats on the rear support fixed
to the polystyrene inner shell (Fig.18).
12.2. Unhook the left front flap from the support fixed to the polystyrene inner shell
by slightly pulling the comfort padding towards the inside of the helmet. Repeat
the same steps for the central front and right front flaps (Fig.19).
12.3. Completely remove the comfort padding from the helmet.
13.
Assembly of the liner
13.1. Properly insert the comfort padding into the helmet.
13.2. Insert the left front flap into its seat on the support fixed to the polystyrene inner
shell and push it downwards until it is completely locked. Repeat the same
steps for the central front and right front flaps (Fig.19).
Note: Check the correct assembly of the liner front area by lifting and lowering
the VPS. These movements should be smooth. If this is not the case, repeat the
steps 12.2 and 13.2.
25
Publicité
Table des Matières
