X-lite X-1004 Sécurité Et Instructions D'utilisation page 22

- Intense sweating/breathing, the use under particular weather conditions (low
temperatures, and/or high humidity and/or sudden changes in temperature
and/or heavy rain) and/or intense and prolonged use may affect the perfor-
mance of the PINLOCK
densation. In such cases, after using the helmet and to restore the system
efficiency, remove the PINLOCK
dry with dry and warm air. The same procedure must be applied to the helmet,
in order to dry out humidity in case it has formed up as a consequence of the
conditions described above.
6. PINLOCK
®
6.1. Remove the visor equipped with the PINLOCK
above).
6.2. Widen the visor and release the PINLOCK
6.3. Release the visor.
Maintenance and Cleaning
- Remove the PINLOCK
gently clean it with neutral liquid soap. Remove the soap under running water.
- Dry the inner visor with dry and warm air without wiping it.
- To keep the features of the inner visor in good conditions over time, let the
helmet dry in a ventilated and dry place with the visor open after use. Keep it
away from heat sources and store it in a place away from direct light.
- Do not use solvents or chemical products.
VISION PROTECTION SYSTEM (VPS)
The exclusive inner VISION PROTECTION SYSTEM (VPS) is a LEXAN™(*) poly-
car-bonate moulded sunscreen with scratch-resistant/fog-resistant treatment. It is
very simple and practical to use. Just lower to activate it or lift to remove it from the
field of vision. It is useful in all sorts of situations, both on long journeys out of town
and shorter town trips.
Moreover, the innovative fastening system allows you to assemble and disassemble
the sunscreen without the need for any tools for ordinary maintenance and cleaning
operations.
VPS Operation
The VPS mechanism allows to activate the sunscreen by simply lowering it until it
partially covers the visor field of vision. In this way, the desired light transmittance
reduction is achieved. At any time, without operating the visor, the VPS can be deac-
tivated with a simple movement and easily lifted up to restore the normal conditions
of visibility and protection guaranteed by the approved helmet visor.
(*) LEXAN is a trademark of SABIC.
inner visor and cause fogging or formation of con-
®
Inner Visor Disassembly
inner visor from the visor. Using a damp and soft cloth,
®
inner visor from the helmet visor and let it
®
®
inner visor from the pins (Fig.9).
®
22
inner visor (see instructions