Switching A Call From Desk Telephone Handset To Headset; New Master Headset Pairing To Base - Jabra GN Netcom GN9350 Guide D'installation Et D'utilisation

• Press the headset's talk button.
• Press the base's telephone mode button.
–> The headset's link indicator will stop flashing to indicate that the headset-base link
has been closed.
Important: If using electronic hookswitch on your telephone, do not place the headset into
the charging cradle, press the headset´s talk button or press the base´s telephone mode button,
as this will disconnect the call.
If the headset runs out of battery power, the headset-base link will remain active for up to 2
minutes to allow for battery changing.
GN 9350 GN 9330
4.6 Switching a call from desk telephone handset to headset
It's possible to switch a call in progress from the telephone's handset to the headset:
1. Remove the headset from base, or if already out, press
the headset's talk button. This establishes a link.
–> The headset's link indicator will start flashing and the
call will be switched to the headset.
Note: Do not place handset before the call is over, as this will end
the call.
GN 9350 GN 9330
4.7 New master headset pairing to base
You may designate a new master headset for your base.
Important: �efore designating a new master headset, ensure
that the original headset's link to the base unit is closed by
pressing its talk button. The telephone or US� indicator should
not have a flashing light.
To designate a new master headset:
1. Place the new master headset into the charging cradle of the base.
2. Press the base's pairing button.
–> �oth the telephone and US� mode buttons on the base, and the headset's link indica-
tor, will light for 2 seconds. This indicates successful pairing of the new master headset.
GN 9330 USB
GN 9330 USB
13