Adding A Network Hdd; Checking The Hdd Status; Setting Up The Hdd Alarm - Abus eytron TVVR50011 Manuel Utilisateur

Device menu
Warning:
If only one HDD is installed and this is set to If only one HDD is installed and this is set to
"Read-only", then the device cannot make r only", then the device cannot make re-
cordings.
Redundancy:
At least two HDDs are installed.
The redundant HDD makes an extra copy of the The redundant HDD makes an extra copy of the
recordings. This is used as a data backup. recordings. This is used as a data backup.
R/W
•
At least one HDD must have the R/W status one HDD must have the R/W status
(Read/Write). Otherwise, no recordings are possible. (Read/Write). Otherwise, no recordings are possible.

Adding a network HDD

Note
Pay attention to the network information on page Pay attention to the network information on page
49.
Parameter
NetHDD No.
Type
NetHDD IP
NetHDD Directory
Enter the parameters to add a network HDD. Enter the parameters to add a network HDD.
Note
The network must be active to record on the ne
work HDD.
For example, check whether a night service or For example, check whether a night service or
similar is installed which switches off network ac- similar is installed which switches off network a
tivity.
38
Setting
1–8
NFS
IP address IP address
Directory name Directory name
record on the net-

Checking the HDD status

The status of each HDD can be checked in the "Mainte- The status of each HDD can be checked in the "Maint
nance" menu. S.M.A.R.T. information (Self S.M.A.R.T. information (Self-Monitoring,
Analysis and Reporting Technology) is stored in the log Analysis and Reporting Technology) is stored in the log
data.
Call up the log file and search according to the infor- Call up the log file and search according to the info
•
mation/S.M.A.R.T. HDD (see page 47). mation/S.M.A.R.T. HDD (see page

Setting up the HDD alarm

You can specify alarms to inform you of HDD errors. You can specify alarms to inform you of HDD errors.
To do this, call up "Exception" in the "System Set- To do this, call up "Exception" in the "System Se
•
tings" menu (see page 44).
status
alarm
).