Tests; Accident Prevention; Warranty / Warranty Conditions - Storch 120 Compact Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26

Tests

The machine must be inspected by an expert every 12 months, in line with the "Regulations for fluid spraying equip-
ment", to ensure that continued safe operation is possible. The results of the inspection must be documented. No spe-
cific format is required for the documentation.

Accident prevention

The machine is designed to avoid accidents if used as intended. The operator must be informed of the danger of injury
due to hot machine parts and the high pressure jet. Observe the "Regulations for fluid spraying devices".
Oil change
Before starting up, always check the oil level at the sight glass. (Make sure the appliance is in a horizontal position!)
The oil level should be in the middle of the oil sight glass. In case of high humidity levels and temperature fluctuations,
some condensate may form; you must change the oil in this case (grey colour).
First oil change after approx. 50 hours of operation. Following this, no oil change is required for the appliance's service
life. If you need to change the oil to perform repairs, or because the oil colour is grey, open the oil drain screw above a
catchment tray and drain the appliance. Use a catchment tray to catch the oil, and dispose of the oil in line with legal
requirements. New oil: 0.25 l - engine oil W 15/40.
Oil leaks
If oil escapes, immediately contact your local customer service (dealer). (Environmental damage, transmission damage)
Warranty
Warranty conditions
A warranty period of 12 months from the date of purchase/date of invoice applies to our tools for commercial custo-
mers. If we have granted an extended warranty period, this period will be noted separately in the operating manual for
the equipment in question.
Claims
If you wish to claim under our warranty or guarantee, please return the complete device and your invoice to our logistics
centre in Berka, postage paid, or send it to one of our authorised service centres.
Please contact STORCH Service-Hotline : 08 00. 7 86 72 47 first.
Your rights under our warranty or guarantee
Claims can only be accepted for material defects or manufacturing errors, and only assuming intended use of the appli-
ance. Wear parts such as drives, seals, pistons, valves and bearings are not covered by such claims. Installation of third
party components, improper use and storage, as well as obvious failure to observe the operating instructions will void
your warranty.
Repairs
All repairs have to be conducted on our premises or by an authorised STORCH service centre.
Translation of the original instruction
60

Publicité

Table des Matières
loading

Table des Matières