Electric Connection; Water Connection; Installation: Location - Storch 120 Compact Mode D'emploi

Motor protection switch
The motor is protected against overload by a motor protection switch. In event of overload, the motor protection switch
switches off the motor. If the motor keeps on switching off as a result of the motor protection switch, eliminate the
cause (see page 7/8).
Replacement and test work must only be carried out by qualified and authorised experts with the machine
disconnected from the electric network thus, with the mains plug pulled out.
Installation:
Site
The machine must not be run in rooms with a risk of fire or explosion, or positioned and operated in puddles.
Never operate the device in water.
WARNING:
Never draw in fluids containing solvents such as pain thinners, petrol, oil or similar fluids. Observer the
manufacturer's instructions on additives! The seals in the device are not solvent-resistant! The spray from
solvents is highly flammable, potentially explosive and toxic.
WARNING:
High temperatures occur in use with hot water at 60° C.
Do not touch the device without protective gloves.

Electric connection

The machine is supplied with a 5m connecting cable with mains plug. The plug must be be plugged into a
socket that has been installed according to regulations with a 30 mA FI residual current circuit-breaker. The
socket must be secured with a 16 A slow-blow fuse on the mains side.
When using an extension cable, this must be fitted with a circuit breaker that has been connected to the socket accor-
ding to regulations. The conductor of the extension cable must have a minimum cross-section of 2.5 mm². The plug
connection must be splash-water protected version and must not left laying on a wet floor.
Electrical appliances
The device possesses a voltage range which can pose an electrical hazard to humans and animals. It should only be
unscrewed and / or disassembled by authorised personnel.
Similarly, maintenance and repairs must be performed by STORCH, or by a STORCH-authorised service centre. Use of
the appliance is upon your own responsibility and at your own risk.

Water connection

Please check whether the water flow (litres per minute)
stated on page 51 (Technical Data) is available to the high
pressure cleaner.
Check: Allow the water feed hose to run into a bucket for
1 minute. The water flow must match the specification on
page 3 at a minimum!
A lack of water causes rapid wear on the seal
(not covered by warranty).
Translation of the original instruction 52