Scan Slides Or Negatives - HP Scanjet 7600 Série Guide De L'utilisateur

Connect the TMA cable to the scanner
1 Disconnect the power cable from the scanner.
2 On the back of the scanner, find the round TMA port.
3 Holding the TMA cable by its free end, align the connector so that the arrow is on
the top side.
TMA cable and port
4 Gently insert the connector into the TMA port.
Caution
bend or break internal pins.
5 Reconnect the power cable.

Scan slides or negatives

To scan standard 35 mm slides or negatives, use the transparent materials adapter
(TMA) light source and the positioning plate. For negatives, use the negative holder.
When scanning fewer than three slides, use the slide light shield; when scanning fewer
than four negative frames, use the negative light shield.
Start the scanning process
1 Place the positioning plate on the scanner glass, and match the reference mark on
the plate to the reference mark on the scanner.
Place the positioning plate on the scanner glass
2 Insert slides or negatives into the TMA light source. See below for details.
User's manual
Do not force the cable into the TMA port. Forcing the cable can
13