2595KL ASSEMBLY INSTRUCTIONS
Parts List:
(1) Chair Scale Assembly
(2) Wheels
(2) Feet
(2) Wheel Screws
(1) Power Adapter
Remove each assembly from its carton and unwrap packing material carefully to prevent
scratching the parts.
1.
Place the chair scale assembly upside down on a level floor.
2.
Unscrew 2 screws from both wheel supports. Attach the wheels to both sides of the
chair assembly and replace the screws (use 3/16" or 5mm Allen wrench).
3.
Screw the two plastic feet onto the chair assembly.
4.
Turn the chair scale assembly right side up and adjust the feet for equal stabilization of
the chair assembly.
NOTE: The scale may be operated by a power adapter (included) or by 6 C-cell batteries
(not included). The scale will automatically switch to battery power when a power adapter
is absent or not plugged in, if there are batteries in the scale.
Figure 1. Assembly of the 2595KL
3