Filling The Container - Ryobi RY18BPSA Traduction Des Instructions Originales

■ Liquids to be sprayed must be as thin as water. Thicker
liquids will not spray properly.

FILLING THE CONTAINER

■ Stand the product on a level surface, and do not fill the
container above the maximum mark.
■ When filling from the central water supply, do not
immerse the end of the hose in the solution. Sudden
low pressure in the system may cause the solution to
be sucked back into the water supply.
■ Before filling the container with spray solution, carry out
a test run with fresh water, and check all parts of the
product for leaks.
■ After filling, fit the filler cap, and tighten it down firmly.
■ Hang a tag to the product to note what chemical is
being used.
■ Spray materials may be premixed and poured into the
spray tank using a funnel, if necessary.
NOTE: Thoroughly clean and rinse measuring
containers that are used for fi lling the tank and for
premixing spray materials.
APPLICATION
■ Work only in the open or in well-ventilated locations,
e.g. open greenhouses.
■ Adjust the pressure by rotating the cone nozzle or
changing to a fan nozzle.
■ Too high or too low pressure or unfavourable
weather conditions can result in the wrong solution
concentration. Overdosing may damage plants and the
environment. Underdosing may result in unsuccessful
plant treatment.
■ To reduce the risk of damage to the environment and
plants, do not operate the product:
● if pressure is too high or too low
● in windy conditions
● in direct sunlight
■ Avoid using the product in freezing weather because
the solution may freeze.
FEATURES
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all
operating features and safety rules.
NOZZLE KIT
Cone nozzle, 0 DEG~60 DEG, and fan nozzle, 120 DEG.
TANK
The tank has a maximum capacity of 15L (4 US gal).
TRIGGER WITH LOCK-ON LATCH
Squeezing the trigger releases a stream of spray solution
for spraying consumer grade home and garden chemicals.
The lock-on latch enables continuous spraying without
holding down the nozzle.
6 | English
ON/OFF SWITCH
The on/off switch is easily accessible while wearing the
product to turn the product on or off.
PRESSURE PROTECT SWITCH
The pressure protect switch turns off the product when the
maximum pressure is reached.
BATTERY COVER
The battery cover protects the battery from exposure to
liquids.
HOUSING DRAINAGE
The housing drainage prevents short circuits that may
result from water leakages.