Faber AGIO 24 Instructions D'installation page 12

12
Front
Strip
CUSTOMIZING YOUR RANGEHOOD
The front strip of the rangehood can be customized. The front strip is attached to the
rangehood by three recessed screws and three key hole slots on the back side of the strip.
It is necessary only to remove the three lower screws to remove the front strip. The
top screws will slide out of the key holes once the three lower screws are removed.
The front strip dimensions are shown above. If you wish to keep the frame of the front
panel and only replace the glass panel, the dimensions follow:
Height = 5
11/16"
13
ELECTRICAL INSTALLATION WITH CONNECTION CABLE
GROUNDING INSTRUCTIONS This
appliance must be grounded. In the
event of an electrical short circuit,
grounding reduces the risk of electric
shock by providing an escape wire for
the electric current. This appliance is
equipped with a cord having a ground-
ing wire with a grounding plug. The plug
must be plugged into an outlet that is
properly installed and grounded.
WARNING - Improper grounding can
result in a risk of electric shock.
Consult a qualified electrician if the
grounding instructions are not com-
pletely understood, or if doubt exists
as to whether the appliance is properly
grounded.
12
Three Screws
23
5/8"
, Depth = 1/8", Width = 29
Rangehood Body
- 29
7/8"
(for 30" model) 23
11/16"
Do not use an extension cord. If the power
supply cord is too short, have a qualified
electrician install an outlet near the appliance.
5
7/8"
13/16"
(for 24" model).
5/8"
Max. 33
7/16
"