Dimensions; Changing The Batteries; Moving And Storage - Tunturi S30 Mode D'emploi

MAINTENANCE
The S30 requires very little maintenance. Check,
however, from time to time that all screws and
nuts are tight, and apply light grease or vaseline
to the pivot points of the shocks if necessary.
Clean the climber from dirt and dust with a damp
cloth or towel. Do not use solvents.
If the device is not functioning properly during
use, contact your Tunturi dealer immediately.
Always give the model (S30) and the serial
number of your device.
Despite continuous quality control, faults or
malfunctions due to individual components may
arise. It is, however, unnecessary to send the
whole device to be repaired as the fault can
in most cases be repaired by replacing the
component in question.

CHANGING THE BATTERIES

If the meter display becomes very weak or
there is no display at all, change the batteries.
Remove the meter from its mount on top of the
main mast. Open the battery cover on the back
of the meter case and remove the old batteries.
Insert new batteries (two 1.5 V AA-batteries) to
the battery case following the + and - markings.
Push the battery case cover back into place. Slide
the meter onto its mounting on top of the vertical
frame.

MOVING AND STORAGE

The stepper is easy to move by pushing along on
the integrated transport wheels. Tilt the stepper
from the front and push along the floor on the
wheels at the bottom of the main mast.
Place the equipment on a firm, level surface, and
on a protective base to avoid any damages to the
floor beneath the equipment. Notice that certain
floor materials may require protection when
transporting the equipment.
To prevent malfunctioning, store the stepper in a
dry space with as little temperature variation as
possible, protected from dust.
O W N E R ' S M A N U A L

DIMENSIONS

Length 87 cm
Height 141 cm
Width 86 cm
Weight 32 kg
This product carries the CE label.
All Tunturi steppers meet EN precision and
safety standards (EN-957, parts 1 and 8).
Due to our continuous policy of product
development, Tunturi reserves the right to change
specifications without notice.
GB
•
S 3 0
5